Section 3
Installation
Caution: Before you proceed, be sure to read and become familiar with the safety precautions at the beginning of this manual. If you have any questions, seek expert advise before you proceed. Do not proceed if you are unsure of the safety precautions or any procedure.
This section describes the expansion board installation procedure.
Receiving & Inspection
1.Observe the condition of the shipping container and report any damage immediately to the commercial carrier that delivered your control.
2.Remove the control from the shipping container and remove all packing materials from the control. The container and packing materials may be retained for future shipment.
3.Verify that the part number of the control you received is the same as the part number listed on your purchase order.
4.Inspect the control for external physical damage that may have been sustained during shipment and report any damage immediately to the commercial carrier that delivered your control.
5.If the control is to be stored for several weeks before use, be sure that it is stored in a location that conforms to published storage humidity and temperature specifications stated in this manual.
Board Installation
Caution: Static electricity damages electrical components. This board has static sensitive components installed. Be sure to comply with ESD (Electro Static Discharge) procedures when handling circuit boards and components.
1.Remove the expansion board from the shipping container.
2.Remove all packing material from the board.
Caution: Be sure all packing materials are removed from the board. Conductive foam may be present on the connectors to prevent static build up during shipping. This can prevent proper circuit operation.
Installation 3‐1
