Barco R5976934 user manual BNC SDI / Hdsdi

5. The On Screen Display (OSD)

The following sources can be connected to the monitor:
Input		Interface	signals
Video system input	VIDEO IN	RCA	NTSC/PAL
	S-VIDEO	S-Video Mini Din 4pin	NTSC/PAL
	YUV (Y Pb/Cb Pr/Cr)	Component Mini Din 8 pin	NTSC/PAL
RGB input	RGB Analog	D-Sub 15 pin	RGB analog
	RGB Digital	DVI-D 24 pin	RGB digital
HD-SDI input	Serial Digital	BNC	SDI / HDSDI

To select a signal, proceed as follows:
RCU	Icon	Push button (1: top most)
• Press the ADJ key to activate the OSD		• Press 7 to activate the OSD
• Use the left and right cursor keys to navi-		• Press 3 and 4 to navigate to the
gate to the signal menu		signal menu
• Press Enter to select		• Press 2 to select
• Use the down cursor keys to open the		• Press 4 to open the input signal
input signal selection dialog		selection dialog
• Use the left and right cursor keys to select		• Press 3 and 4 to select the desired
the desired signal		signal

In case the signal is assigned to input 1, it cannot be assigned to input 2!

To change the signal of input 1 and input 2, input 1 has to be assigned to the signal which up to then has been assigned to input 2.

In case of two valid signals, input 2 then will automatically be assigned to the signal which up to then has been assigned to input 1.

In case of more signals, input 2 has to be explicitely assigned to a signal (all but the one assigned to input 1).

To select HD-SDI input 1 or HD-SDI input 2, first select HD-SDI in the OSD. When it is highlighted, press 1 to select the signal connected to HD-SDI input 1, or press 2 to select the signal connected to HD-SDI input 2.

5-42 __________________________________________________________Barco - LC series - R5976934 - user's manual - Revision 08 - April 2008