
5. Getting started
Why a projector address ?
As more than one projector can be installed in a room, the separate projector should be separately addressable with an RCU or
computer. Therefor each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software.
Projector controlling.
Everyprojector requires an individual address between 0 and 255 which can be set in the Installation menu.
When theaddressisset,theprojectorcanbecontrolledby:
• RCU for addresses between 0 and 9.
• computer,e.g. IBMPC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Aproje ctor willrespond to a R CU set to the common address ’0’ regardless of what address is set in the projector itself (common
address of projector should also be “0” ).
TheR CU is default programmed with address 0 , ’common address’.
Ifit is necessary to control a specific projector, then enter the projector address into the RCU (only when that
addressis between 0 and 9). Theprojecto rw ith the corresponding address will listen to that specific RCU.
Some projectors may operate in domestic environments where other equipments may listen to the common
address “0” , therefore the common address can also be set to “1”.
5.7.2 Displaying and Programming addressesinto the RCU
Displaying the Projector Address on the Screen.
1. Press the Address key (recessed key on the RCU) with a pencil.
The projector’s address will be displayed in a ’Textbox’
To continue using the RCU with that specific address, it is necessary to enter the same address with the
digitbuttons (add ress between 0 and 9) within 5 seconds after pushing the address key. For example : if the
Addresskey displays projector address 003, th en press "3" digit button on the RCU to set the RCU’sad dress
tomatch the projector ’saddress. Donot press 0–0–3 . Thiswill address the remote control to ’0’ and control
allprojectors in the room. If the address is not entered within 5 sec onds, the RCU returns to its default address
(zeroad dress) and controls then all projectors in the room.
Address0 (or 1) should alw ays allow communication with the projector since it is a common address.
Displaying the Projector Address in Standby.
1. Press the Address key (recessed key on the RCU) with a pencil.
All the LED’son the front of the projector go out.
ThenLED1 starts blinking green the number of hundreds. Afterthat LED2 starts blinking the number of tens. Finally LED3 starts
blinkinggreen the num ber of units. If this is done, the original status of the leds is restored.
5.8 Digital ZoomWhat can be done ?
TheDigital Zoom key on the RCU a llowsto zoom (in or out) one particular part of the image
How to Zoom ?
1. Press ←or →on the Digital Zoom key on the remote to Z oom the center of the image
Awizardbox is displayed in the lower part of the screen, follow the instructions.
Use the BACK key to undo the Zoom function.
36 R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004