14. Installation menu
Themenu item is stored behindthe quick access key. The message Quick Access key stored will be displayed.
14.6 RS232 baudrate

How to change the baudrate?

1. Press MENU to activate the menu bar.
2. Press →to select the Installation item. (image 14-14)
3. Press ↓to pull down the Installation menu.
4. Use ↑or ↓to select RS232 baudrate
5. Press →to pull down the menu.
6. Use ↓or ↑to select the desired baudrate.
7. Press ENTER to confirm.
Image14-14
14.7 Automatic startup
What can be done ?
Thea utomaticst artup allowsimmediate restart of the projector after a power failure (breakdown), i.e. without passing through the
standby state.
Theprojector restarts at power resum e and recovers the previous settings (previous source,...).
Thisfunction can be disabled if undesired or inadequate for safety reasons, etc.

CAUTION:If the Automatic startup function is enabled one must be aware of the fact that it involves safety

precautions
Makesure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.

How to enable/disable the Automatic startup?

1. Press MENU to activate the menu bar.
2. Press →to select the Installation item. (image 14-15)
3. Press ↓to pull down the Installation menu.
4. Use ↑or ↓to select Automatic startup .
5. Press →to pull down the menu.
6. Use ↓or ↑to enable/disable the automatic startup.
130 R5976815 RLM G5I PERFORMER 02/06/2006