4. Getting Started
4.2 Switching on

How to switch on.

1. Press the power switch to switch on the projector.
- When ’0’ is pushed in, the projector is switched off.
- When ’1’ is pushed in, the projector is switched on
The projector starts in standby mode, LED1 is red.

Starting image projection.

1. Press Standby key once on the local keypad or on the remote control.
Note: Itmay take about 60 seconds before image projection, i.e. noprojection until the completion of several operations (soft-
ware initialization,...).
Note: If the Security mode is enabled, a text box will be displayed for PIN code entry, see Security setting in the Installation
menu
Note: IfIden tificationscreen is on, the Identification screen will be displayed during start up.

CAUTION:Pushingthe stan dby key too long, might cause the projector to shut down right after an image is

displayed.
4.3 Lamp runtime
x
Togeneralize for the different projector types, xrefers here to the maximum run time of the lamp. Themaximum run
time is given in the specifications.

Lamp runtime indication while running

Independentlyof the lamp mode, when the total runtime of an active lamp (lamp 1 for example) is (x -30) hours or more, a warning
message will be displayed.
WARNING !!!
LAMP 1: 1471 hrs
LAMP 2: 1400 hrs
Image4-3
warningmessage
Thiswarning message will be repeate d at the next start up. Press BACK or MENU to remove the message.
The total lifetime of the lamp (singlelam p)for a safe operation is x hours max., do not useit longer. Always replace with a same
typeof lamp. Call a Barco authorized service technician for lamp replacement.
Lampmanagement when the lamp r untime is reached in the differentlamp modesis indicated in the next image.
34 R5976815 RLM G5I PERFORMER 02/06/2006