oLoosen the burner screw (V) and then carefully pull the burner away from its support. IMPORTANT: Care must be taken to ensure that no damage is caused to the ignition plug or the thermocouple.
oUnscrew the injector using a 10 mm spanner and replace it with the stipulated injector for the new gas supply (see table below).
Burner | Types | Pressure | Injector | Gas |
| Power | ||
| of gas | (mbar) | Marking | consumption | (kW) | |||
|
|
| (1/100 | g/h |
| l/h | Max. | Min. |
|
|
| mm) |
|
|
|
|
|
Oven | Natural | 20 | 150 | - |
| 429 | 4.50 | 2.00 |
| (G20) |
|
|
|
|
|
|
|
| Butane | 28 | 218 |
| - |
|
| |
| (G30) |
|
|
|
|
|
|
|
| Propane | 37 | 214 |
| - |
|
| |
| (G31) |
|
|
|
|
|
|
|
Grill | Natural | 20 | 115 | - |
| 191 | 2.00 | N/A |
| (G20) |
|
|
|
|
|
|
|
| Butane | 28 | 68 | 145 |
| - |
|
|
| (G30) |
|
|
|
|
|
|
|
| Propane | 37 | 68 | 143 |
| - |
|
|
| (G31) |
|
|
|
|
|
|
|
IMPORTANT: You must change the oven and grill injectors.
IMPORTANT: After changing the injectors YOU MUST follow the minimum flow adjustment section below.
Minimum flow adjustment for the oven and grill burners
All work must be carried out by a GASSAFE registered engineer.
oLight the burner and set the knob at the minimum position.
o Remove the knob from the tap and place a small bladed screwdriver in the screw indicated in the picture opposite.
o Unscrew the adjusting screw, in order to increase the gas flow or tighten the adjusting screw to decrease the gas flow.
35
