oFor butane/propane gas, the adjusting screw must be tightly screwed in.
oRefit the control knob.
oMake sure that the flame does not go out by quickly turning from maximum flow to minimum flow. If it does then remove the control knob and make further adjustments to the gas flow, testing it again once the adjustment has been made.
oIMPORTANT: On completion carry out a gas tightness test.
Gas adjustment (Conversion to LPG for the oven and grill)
All work must be carried out by a GASSAFE registered engineer.
IMPORTANT: Always isolate the cooker from the electricity supply before changing the injectors and/or adjusting the minimum flow of the burners.
o Remove the burner base from the bottom of the oven.
o To do so, loosen the two retaining screws holding it in place. Then lift the tray from the back.
o Once it is out, slide the tray towards the rear and take it off.
34
