Belkin F506230-3 user manual Troubleshooting, mask, and gateway address. Make

Troubleshooting

The WAN link LED is not on or	1. Check the connection between
I cannot connect to the cable or	the Router and the cable or DSL
DSL modem.	modem. Make sure the network
	cable from the cable or DSL
	modem is connected to the port
	on the Router labeled "WAN".
	2. Make sure the cable or DSL
	modem is powered and
	switched on.
	3. Make sure the Router has power.
	The Amber LED on the bottom
	of the front panel should
	be illuminated.
	4. Some cable or DSL modems
	require a crossover cable. Check
	with the manufacturer of your
	Cable/DSL modem for specifics
	about this.
My connection type is Static IP	1. Since your connection type is
Address. I cannot connect to the	Static IP Address, your ISP must
Internet.	assign you the IP address, subnet
	mask, and gateway address. Make
	sure that the Router’s connection
	type is configured as "Static IP
	Address" and verify your settings.
	2. Your ISP may bind your
	connection to the MAC address
	of your computer’s NIC. Clone
	your MAC address.
My connection type is Dynamic	1. Make sure your computers are
IP Address. I cannot connect to the	correctly configured and all
Internet.	network cables are properly
	connected.

64