Chapter 3 Removing and Replacing Covers
12
Bezel
The bezel has three clips that mount onto a hinge assembly, which is secured to
the NetServer chassis. To remove the bezel, simply pull it toward you until it
comes free from the NetServer (see Figure 3-3).
Figure 3-3. Removing the HP NetServer LH 4r Bezel
CAUTION Do not unscrew the NetServer from the rack until you have
extended the anti-tip foot from under the front of the rack.
This anti-tip device must be extended to prevent the rack and
NetServer from tipping over, which could damage the
NetServer and injure people.
If it is secured to the rack, unscrew the NetServer chassis from the rack, as shown
in Figures 3-4 (front) and 3-5 (rear).
Do not unscrew the entire hinge or bracket from the NetServer. Remove only the
outer screws so the hinge and the bracket remain attached to the NetServer
chassis.