Belkin PM01122EA-B Connection Type to Static IP, IP Address, Subnet Mask, ISP Gateway Address

Alternate Setup Method

Table of Contents sections 1 2 3 4 5 6 7 8 9 10

Setting your Internet Service Provider (ISP)

Connection Type to Static IP

A static IP address connection type is less common than other connection types. If your ISP uses static IP addressing, you will need your IP address, subnet mask, and ISP gateway address. This information is available from your ISP or on the paperwork that your ISP left with you. Type in your information, then click “Apply Changes”

(4). After you apply the changes, the Internet Status indicator will read “Connected” if your Router is set up properly.

1.IP Address (1)

Provided by your ISP. Enter your IP address here.

2. Subnet Mask (2)

Provided by your ISP. Enter your subnet mask here.

3.ISP Gateway Address (3)

Provided by your ISP. Enter the ISP gateway address here.

Setting your ISP Connection Type to PPPoE

Most DSL providers use PPPoE as the connection type. If you use a DSL modem to connect to the Internet, your ISP may use PPPoE to log you into the service. If you have an Internet connection in your home or small office that doesn’t require a modem, you may also use PPPoE.

Your connection type is PPPoE if:

1)Your ISP gave you a user name and password, which is required to connect to the Internet.

2)Your ISP gave you software such as WinPOET or Enternet300 that you use to connect to the Internet.

3)You have to double-click on a desktop icon other than your browser to get on the Internet.

(1)

(2)

(3)

N Wireless Router 30