BenQ MP511 user manual Connecting an S-Video or a composite Video source device

Connecting an S-Video or a composite Video source device

Examine your Video source device to determine if it has an unused S-Video output socket available:

•If so, you can continue with this procedure.

•If not, you will need to reassess which method you can use to connect to the device.

If you have already made a Component Video connection between the projector and the video source device, you need not connect to this device again using an S-Video or composite Video connection as this makes an unnecessary second connection of poorer picture quality. You need only connect using a composite Video connection if both Component Video and S- Video are not supplied on the video source device (for example, with some analog video cameras).

See "Connecting Video source devices" on page 21 for details.

To connect the projector to an S-Video source device:

1.Take an S-Video cable/Video cable and connect one end to the S-Video/Video output socket of the Video source device.

2.Connect the other end of the S-Video cable/Video Cable to the S-VIDEO/VIDEO

socket on the projector.

The final connection path should be like that shown in the following diagram:

A/V device

Video cable or S-Video cable

If the selected video picture is not displayed after the projector is turned on and the correct video source has been selected, check that the Video source device is turned on and operating correctly. Also check that the signal cables have been connected correctly.

Connection 23