Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1
1.Press the
lift the front of the projector. Once the image is positioned where you want it, release the
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
2. Screw the rear adjuster foot to fine tune the horizontal angle.
To retract the foot, hold up the projector
while pressing the
If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected image becomes trapezoidal. To correct this situation, adjust the value of Keystone in the DISPLAY menu, on the projector control panel, or remote control. See "Correcting keystone" on page 29 for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector or remote control. Within 3 seconds, the
The current source information will be displayed in the upper left corner of the screen for 3 seconds.
The screen will be blank while AUTO is functioning.
Fine-tuning the image size and clarity
If needed, sharpen the picture by rotating the focus ring.
