1.Press CAPTURE on the remote control.
2.A confirmation message displays. Press CAPTURE or MODE/ENTER again.
3.The message 'Screen Capturing...' displays while the projector is processing the picture. Please wait.
4.If the action is successful, you see the message 'Captured Succeeded' on the screen. The captured picture is saved as My Screen.
5.To view the captured picture displayed as the startup screen, set My Screen in the
SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.
•Using the OSD menu
1.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Basic menu is highlighted.
2.Press 
to highlight MyScreen and press MODE/ENTER.
3.Repeat steps
captured picture.
In the unlikely event that the capturing action fails, change your target picture.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure you have made a correct connection to the projector audio input. See "Connection" on page 15 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted.
2.Press 
to highlight Audio Settings and press MODE/ENTER. The Audio Settings page displays.
3.Highlight Mute and press 
/ 
to select On.
Adjusting the sound level
To adjust the sound level, press VOLUME+/VOLUME- on the remote control, or:
1.Repeat steps
2.Press 
to highlight Volume and press 
/ 
to select a desired sound level.
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.Repeat steps
2.Press 
to highlight Power On/Off Ring Tone and press 
/ 
to select Off.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound mute or changing the sound level will not affect the Power On/Off Ring Tone.
