Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.
Go to http://lamp.benq.com for a replacement lamp.
The LAMP indicator light and TEMPerature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 59 for details.
The following Lamp warning displays will remind you to change the lamp.
Status | Message | |
Install a new lamp for optimal performance. If the | Notice | |
projector is normally run with Economic selected | ||
| ||
(See "Getting to know the lamp hour" on page 54), | Order Replacement Lamp | |
you may continue to operate the projector until | ||
Lamp>XXXX Hours | ||
the next hour lamp warning appears. | ||
| ||
Press MODE/ENTER to dismiss the message. | Order a new lamp at lamp.benq.com | |
| ||
| OK | |
|
| |
It is strongly recommended that you replace the | Notice | |
lamp at this age. The lamp is a consumable item. | ||
| ||
The lamp brightness diminishes with use. This is | Order Replacement Lamp | |
normal lamp behavior. You can replace the lamp | ||
Lamp>XXXX Hours | ||
whenever you notice that the brightness level has | ||
| ||
significantly diminished. | Order a new lamp at lamp.benq.com | |
Press MODE/ENTER to dismiss the message. | OK | |
|
| |
The lamp MUST be replaced before the projector | WARNING | |
will operate normally. | ||
Out of Lamp Usage Time | ||
Press MODE/ENTER to dismiss the message. | ||
| ||
| Replace lamp (refer to User Manual) | |
| Then reset lamp timer | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
|
"XXXX" shown in the above messages are numbers that vary depending on different models.
Maintenance 55
