Power ON/OFF
WARNING
•When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector.
NOTE
•Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.
Turning On The Power
1.Remove the lens cap.
2.Set the power switch to [ ] (ON). The STANDBY/ON indicator will light to solid orange.
3.Press the STANDBY/ON button. The projector lamp will light up and the STANDBY/ON indicator will begin blinking green. When the power is completely on, the indicator will stop blinking and light green.
4.Use the LENS SHIFT buttons to shift the picture upward or downward.
5.Select an input signal according to the section “Selecting An Input Signal” of the following page.
STANDBY/ON
STANDBY/ON button / indicator
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ | + | + |
LENS SHIFT | FOCUS | ZOOM |
– | – | – |
BLANK | ASPECT | LASER |
STANDBY/ON STANDBY/
ON button
Power switch (ON position)
LENS SHIFT
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ + +
LENS SHIFT FOCUS
– – –
LENS SHIFT buttons
Turning Off The Power
1.Press the STANDBY/ON button. The
| STANDBY/ON |
| |
message “Power off?” will appear on the | STANDBY/ON button / indicator | ||
screen for approximately 5 seconds. |
|
| |
Attach the lens cap. | LASER INDICATOR |
| |
2. Press the STANDBY/ON button again | STANDBY/ON VIDEO | RGB | |
+ + | + | ||
while “Power off?” the message is visi- | |||
LENS SHIFT FOCUS ZOOM | |||
– – |
| ||
BLANK ASPECT LASER | |||
ble. The projector lamp will go off, and |
|
| |
the STANDBY/ON indicator will begin | STANDBY/ON STANDBY/ | ||
blanking orange. Then the STANDBY/ | |||
ON button | |||
ON indicator will stop blinking and | |||
|
| ||
light to solid orange when the lamp | Power switch (OFF position) |
| |
cooling is complete. |
|
| |
3.Switch the power switch to [O] (OFF). The STANDBY/ON indicator will go off.
4.Attached the lens cap.
14 Power ON/OFF
