ADJUSTING THE BACKSTOP SQUARE WITH THE SANDING BELT

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

1.Before adjusting, move the belt tension lever (A) Fig. 23 all the way to the left to the "TIGHTEN" position.

2.Place a square (B) Fig. 24 on the sanding belt with one end of the square against the backstop. See if the backstop is square with the sanding belt.

3.Loosen the screw (C) Fig. 24 and adjust the backstop.

A

B

Fig. 23

C

Fig. 24

TILTING THE TABLE

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

You can tilt the table up to 45 degrees to the right by loosening the table lock knob (A) Fig. 25.

WARNING: After tilting, the table must be repositioned on the support rod (B) Fig. 25 to provide a maximum of 1/16 in. distance between the sanding disc (C) and the edge (D) of the table to avoid trapping the work or fingers between the disc and the table. To reposition the table assembly, loosen the screw (E), move the table assembly on the rod (B) and tighten the screw.

C

E

A

Fig. 25

D

B

ADJUSTING THE TABLE SQUARE WITH THE SANDING DISC

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

1.Use a combination square with one end on the table and the other end against the sanding disc (Fig. 26). See if the table is 90 degrees to the disc.

2.To adjust, loosen the table lock knob (A) Fig. 26, move the table square with the disc and tighten the lock knob (A).

3.Adjust the pointer (B) Fig. 26 to the "0" degree mark on the angle scale.

B

A

Fig. 26

13

Page 13
Image 13
Black & Decker BDSA100 instruction manual Adjusting the Backstop Square with the Sanding Belt, Tilting the Table