3.Push chuck locking lever (C) Fig. 23, to the rear as shown. This will release the blade (D) from the upper chuck (E).
E
C
D
Fig. 23
4.Insert long end (F) Fig. 24, of quickset blade wrench into hole (G) in lower blade holder. This will align wrench (H) with blade holder screw (J).
J
H
5.Fig. 25 illustrates the quickset blade changing wrench (K) engaged with the lower blade holder assembly. Turn wrench counterclockwise to loosen screw (J) Figs. 24 and 25, and remove blade from lower chuck.
6.Insert new blade into the lower and upper blade holders in the same manner, making certain the blade teeth are pointing down toward the table.
7.Tighten screw (J) Fig. 26, in lower blade guard assembly.
8.Push chuck locking lever (C) Fig. 23, to the foreword position, to lock the blade in the upper blade holder assembly.
9.Replace the table insert that was removed in
STEP 2.
10.Apply blade tension by referring to the following section "ADJUSTING BLADE TENSION."
F
G
Fig. 24
J
K
Fig. 25
J
Fig. 26
12
