Black & Decker FS210LS instruction manual Miter Gage Holder, Disconnect Machine from Power Source

MITER GAGE HOLDER

DISCONNECT MACHINE FROM

POWER SOURCE.

1.Assemble spring clip (E) Fig. 4, to the miter gage holder (A) as shown using a M4x.7x10mm pan head screw (F), 3/16 in. lockwasher and M4x.7 hex nut. NOTE: Hex nut (G) Fig. 5, will fit into the recess at the back of the miter gage holder (A) to keep spring clip (E) Fig. 4, secured to the miter gage holder.

2.Assemble the miter gage holder (A) Fig. 6, to the left side of the saw cabinet using the four M4.2x10mm pan head screws (B) Fig. 7, and 3/16 in. washers (C) from inside saw cabinet.

3.Fig. 8, illustrates the miter gage (D) inserted into the miter gage holder when not in use.

C

B

Fig. 7

E

A

F

Fig. 4

A

G

Fig. 5

A

Fig. 6

D

Fig. 8

10