Black & Decker FS210LS instruction manual Outfeed Support

OUTFEED SUPPORT

1.LOOSELY fasten both brackets (A) Fig. 29, to the bottom left side of the saw table as shown, using two M6x1x15mm phillips hex head screws (B) and M6.1 lockwashers (C). Assemble two remaining brackets to the bottom right side of saw table in the same manner.

A

C

B

2.Insert rod (D) Fig. 30, through holes in brackets (A) as shown. Then thread and tighten one 1/4-20x1/2 in. hex head screw (E) and 1/4 in. flat washer (F) into the front end of rod (D) as shown at (G). Assemble remaining rod to the opposite side of saw in the same manner.

F

Fig. 29

G

D

A

3.Insert rods (D) Fig. 31, into larger holes (H) in outfeed support (J) as shown.

4.Secure outfeed support (J) Fig. 32, to rods (D) using two 1/4-20x1/2 in. hex head screws and 1/4 in. flat washers (K) as shown.

5.Push entire outfeed support assembly (J) Fig. 33, in until it contacts splitter/guard assembly (L) as shown. Then tighten all outfeed support mounting hardware.

6.Place washer on 1/4-20x1/2 in. hex screw and thread into the other end of the rods tp prevent them from coming out of outfeed support brackets.

D

K

J

K

Fig. 32

E

Fig. 30

J

H

D

H

Fig. 31

L

J

Fig. 33

17