Black & Decker FS210LS instruction manual

7.Assemble splitter (H) Fig. 19, to splitter support bracket (B) as shown using M6x1x20mm hex head screw (L), 1/4 in. external tooth washer, and 1/4 in. flat washer.

8.Fasten splitter (H) Fig. 20, to splitter support bracket using 1/4 in. flat washer, 1/4 in. external tooth lockwasher and M6 wing nut (M). NOTE: Before tightening wing nut (M) make certain there is at least a 1/8 in. gap between the bottom edge of splitter (N) and top surface of table (P) and that protrusion “pins” (K) Fig. 20, are inside the slot of splitter assembly (H).

9.Using a straight edge, check to see if the splitter (H) Fig. 21, is aligned with the saw blade (R). If an adjustment is necessary, the splitter (H) can be moved left or right and rotated.

10.When you are certain the splitter is properly aligned with the saw blade, tighten the two screws (C) Fig. 22, that fasten the splitter support bracket to the splitter bracket and tighten screw (G) that fastens the splitter bracket to the pivot rod.

H

L

B

Fig. 19

N

H

MK

P

Fig. 20

RH

Fig. 21

G

C

Fig. 22

14