Black & Decker FS210LS instruction manual Extension Wings, Guide Rail to SAW

EXTENSION WINGS

1. Assemble left extension wing (Fig.23), to the saw table using 1/4-20X1 in.hex head screws (3), 1/4 in.flat washers (6), 1/4 in.lockwashers (3),1/4 in.hex nuts (3).

2.Assemble right extension wing into the threaded holes of the saw using 1/4 in.-20X5/8 in. hex head screws (3), 1/4 in. flat washers (3) 1/4 in. lockwashers (3).

3.With a straight edge, make certain the top, front and rear edges of the extension wings are level with the saw table before tightening three screws which secure extension wing to table.

Fig. 23

GUIDE RAIL TO SAW

1.Holding the guide rail with the larger holes facing you, loosely fasten guide rails (A) Fig. 24, to the four threaded holes (B) in saw table (C) using two 1/4-20 x 1-1/4 in. long screws (D), 1/4 in. lockwashers (E), and spacers (F).

IMPORTANT: Spacers (F) Fig. 24, are positioned between guide rails (A) and saw table (C).

2.Fasten guide rails (A) Fig. 24, to extension wings

(G) through hole (K) using the 1/4-20 x 1-1/4 in. long screw (D), 1/4 in. lockwasher (E), spacer (F), 1/4 in. flat washer (H), 1/4 in. lockwasher (E), and 1/4-20 hex nut

(J). Then tighten all guide rail mounting hardware.

IMPORTANT: Spacer (F) Fig. 24, is positioned between guide rails (A) and extension wings (G).

3.Fig. 25, illustrates the guide rails properly assembled to saw table and extension wings.

	G
	C
A	DE F DE F

H E J K

BB

Fig. 24

Fig. 25

15