Figure J
the folded grey strip is against the back of the cabinet overhang. Tape the Mounting Template securely in place. Check to be sure the Mounting Template is located where you plan to mount the toaster.
NOTE: If the cabinet has an overhang that extends more than 2 inches below the cabinet bottom, a wooden shim (a piece of wood that fits between the Cabinet and the Bracket) will be necessary. Cut a block of wood that is: 16 1/4” x 5 1/2”. Make sure the wood is at least as thick as the amount of the overhang that exceeds 2 inches. Locate and drill holes on the shim for the screws to pass through. (Longer screws may be needed. See Note after Step # 7.)
5. Mark the four drill holes through the Template onto the cabinet bottom with a pencil and remove the Mounting Template. (Figure J)
Cover the counter top to catch drilled wood chips.
CAUTION: Suitable eye protection is recommended to prevent injury from shavings while using a drill.
10
