Figure K
Figure L
6.Make a small starter hole by hammering a nail or using a smaller drill bit. Holding the drill straight and vertical at the hole marks, center and drill up through the bottom of the cabinet. (Figure K)
7.Insert a plastic washer on each screw with the flat side of the washer resting on the cabinet bottom. Drop each screw with the washer in place through a drilled hole from inside the cabinet. Repeat the proce- dure with remaining screws and washers. Thread a nut onto each screw so that approximately 1/4 of the screw is exposed beyond the nut. (Figure L)
NOTE: If it was necessary to use a wood shim (See NOTE after Step #4), you may need to use screws longer than those provided. To deter- mine this, hold the shim firmly against the under- side of the cabinet. Drop one of the screws provided through the cabinet shelf and the shim. Check to see that at least 1/2 inch of the screw is visible to provide secure mounting. If it is not, you will need
11
