![Figure M](/images/new-backgrounds/62704/6270423x1.webp)
Figure M
Figure N
Figure O
8.If you determined you need Spacer Bars (See Step # 2, page 9), place the Spacer Bars on top of each Bracket so that the 2 small tabs on the bars fit into the notches on the Brackets. Slide the Mounting Bracket and Spacer Bars above the nuts through the
9.Push the Spacer Bars/Bracket up against the screws and forward toward the front of the cabinet. Tighten the screw/nut assembly with a screwdriver until the Spacer Bars/Bracket just touches the bottom of the cabinet. (Figure N) The Bracket should move freely front to rear in the slot to fine tune the fit of the Toaster to the cabinet front. Repeat Steps 8 and 9 for the other Bracket.
10.Hold the Toaster in front of you and push it forward into the slots on the Mounting Brackets until it locks into place. The Metal Lip on the top of the Toaster should rest against the cabinet front. (Figure O) The front of the Toaster will extend 11⁄2" beyond the front of the cabinet.
12