Black & Decker T1000 manual NOTE If The Mounting Location

Illustration 2

Figure I

MOUNTING INSTRUCTIONS FOR CABINET WITH OVERHANG

If your cabinet has an overhang — a lip extending below the bottom of the cabinet shelf — follow these simple mounting instructions.

1.Empty your cabinet of its contents before starting to drill. Clean the underside of the cabinet to remove any grease or other residue.

2.To determine whether you need to use Spacer Bars to mount your Horizontal Toaster, use the Cabinet Overhang Ruler on your Mounting Template and measure the cabinet overhang (See Illustration 2). If the overhang measures 1/4”, 3/4”,1-1/4”, or 1- 3/4” inches, you will need Spacer Bars. Instructions for using Spacer Bars are on page 12.

NOTE: If The Mounting Location

Has A Partition: The Mounting Template must be cut and a piece removed to allow for this partition. (Figure I) Measure and cut very carefully. Save any pieces of the Mounting Template you remove.

3.Fold down the grey strip on the Mounting Template at the dotted line.

4.With the doors of the cabinet open, position the Mounting Template under the cabinet so

9