8x8 and 16x16 VGA / HDTV Matrix Switch with Audio, RS232 & IP Control
3.2.1 Naming Functions
The matrix unit can be named. Its name can be up to 10 characters long. To assign or retrieve a unit name:
Command: NU<cr> stands for Name Unit
Response:
xxxxxxxxxx(current name) Rename unit: ___________
No change<cr>
If you hit <cr> or wait 5 seconds (command times out) the unit will respond with: Cancelled<cr>
Otherwise you have 5 seconds to change the name by entering up to 10 ASCII characters followed by <cr>. If you just send a <cr> then the stored name will not be changed. If you enter more than 10 characters, then the 1st 10 characters will be saved as the name and the rest discarded.
3.2.2 Routing Functions
Video routing commands are specified from the point of view of the output. The wildcard character ‘*’ is acceptable for output (but not input).
In addition, these commands can be used to monitor or query the status of system ties. Omitting the input channel will result in a response of the current routing for that output. In entering channel numbers leading zeros are acceptable hence you can specify channel 7 as 07 or just 7.
3.2.2.1 To make a video tie:
Command: CVn,m<cr> stands for Connect Video n = output, m= input (unit accepts leading zeros and spaces are ignored)
Response: CVn,m<cr>
If you enter CVn<cr> then you will get the response as above for the n output
3.2.2.2 To make an audio tie:
Command: CAn,m<cr> stands for Connect Audio n = output, m= input (unit accepts leading zeros and spaces are ignored)
Response: CAn,m<cr>
3.2.2.3 To make a synchronized audio/video tie:
Command: COn,m<cr> stands for Connect Output n = output, m= input (unit accepts leading zeros and spaces are ignored)
17 |
