Chapter 3: Installation
3.1.3 Configuring the Management Agent of the Gigabit Smart Switch Eco Fanless
Via the Web, the switch can set up the management function. Use any one of them to monitor and configure the switch.
Configuring the Management Agent of the Gigabit Smart Switch Eco Fanless through the Ethernet Port
There are two ways to configure and monitor the switch through the switch’s Ethernet port. They are Web browser and SNMP manager. The user interface for the SNMP manager is management
Default IP setting:
IP = 192.168.1.1
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Ethernet LAN
Assign a reasonable IP address, for example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Figure 3-6. Gigabit Smart Switch Eco Fanless.
Managing the Gigabit Smart Switch Eco Fanless through the Ethernet Port
Before you communicate with the switch, you must first configure its IP address or know the IP address of the switch. Then, follow the procedures described next.
1.Set up a physical path between the configured the switch and a PC, using a qualified UTP CAT5 cable with an RJ-45 connector.
NOTE: If a PC directly connects to the switch, you have to set up the same subnet mask between them. However, the subnet mask may be different for the PC in the remote site. See Figure
2. Run a Web browser and follow the menu. Please refer to Chapter 5.
Page 20 |
