Black Box ACXMODH2, ACXMODH4, ACXMODH-RMK manual Specifications, Interconnect Cable 1.2.1 CATx, Page

Chapter 1: Specifications

Table 1-3. Digital audio interface specifications.

Specification	Description
Compatibility	AES/EBU, S/PDIF, EIAJCP1201, IEC 60958
Standards	Dolby digital, DTS, PCM
	• Mini XLR (AES/EBU; symmetrical lockable)
CPU Unit (Inputs)	• Coaxial (S/PDIF; RCA, Cinch)
	• Optical (S/PDIF, TOSLINK®)
	• Mini XLR (AES/EBU; symmetrical, lockable)
CON Unit (Outputs)	• Coaxial (S/PDIF, RCA, Cinch
	• Optical (S/PDIF, TOSLINK)

1.2 Interconnect Cable

1.2.1 CATx

NOTE: A point-to-point connection is required. Operation with several patch fields is possible. Routing over an active network component, such as an Ethernet hub, router, or switch, is not allowed.

•Avoid routing CATx cables along power cables.

•If the site has 3-phase AC power, make sure that the CPU module and CON module are on the same phase.

CAUTION: To maintain regulatory EMC compliance, you must use correctly installed shielded CATx cable throughout the interconnection link. Also, all CATx cables need to have ferrites on both cable ends close to the device.

Type of Interconnect Cable

The DKM Modular Extender requires interconnect cabling specified for Gigabit Ethernet (1000BASE-T). The use of solid-core (24 AWG), shielded, CAT5e (or better) is recommended.

Table 1-4. CATx interconnect cable specifications.

ParameterDescription

S/UTP (CAT5e) cable according to EIA/TIA-568-B. Four pairs of

CATx solid-core cable 24 AWG 24 AWG wires. Connection according to EIA/TIA-568-B (1000BASE-T).

S/UTP (CAT5e) cable according to EIA/TIA-568-B. Four pairs of

CATx patch cable 26/8 AWG 26/8 AWG wires. Connection according to EIA/TIA-568-B (1000BASE-T).

NOTE: You can use flexible cables (patch cables) type 26/8 AWG; however, but you’ll only get half the maximum possible extension distance (Table 1-5).

ACX1MT 724-746-5500 blackbox.com Page 11