Blaupunkt DM2000 manual Installations, Supplied Mounting Hardware, English, Français, Precautions

Installations

Supplied Mounting Hardware

ENGLISH
Sleeve	Bushing,	Locking	Mounting Strap	Release
	Screw	screw	and Screw	Keys

FRANÇAIS	Precautions
	• Be sure to detach the front panel before you start in-
	stalling the unit.
	• Choose the mounting location carefully so that the unit will
	not interfere with the normal driving operations of the driver.
	• Use only the supplied mounting hardware for a safe and
	secure installation.
	• When mounting the unit in a car, keep the unit as level as
	possible. If the unit must be mounted at an angle, due to the
	design of the vehicle, make sure that the unit does not tilt
	upward by more than 30°.

Mounting Strap Use

3. Attaching the Mounting Strap to the underside of the dash board, using screw.

Attach the back of the unit to the Mounting Strap using the support stem bolt and hardware.

Bushing Use

3. As shown in the figure below, securely fasten the screw, which has been inserted into the bushing to the rear of the set.

Fire wall

If your car has no accessory position on the ignition key switch (POWER SELECT switch)

The illumination on the front panel is factory-set to be turned on even when the unit is not being played. However, this set- ting may cause some car battery wear if your car has no ac- cessory position on the ignition key switch. To avoid this bat- tery wear, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the RESET button. The illumination is reset to stay off while the unit is not being played.

Reset button

Press the reset button with the point of a sharp object such as a ball-point pen.

ESPAÑOL	Mounting Example
	Installation in the dashboard.
	1.	Install the sleeve in the dashboard.
PORTUGUÊS	2.	Select and bend the appropriate tabs to hold the sleeve
		firmly in place.
	E-10

The distance to the fire wall varies due to the type of the car. Be sure to secure the unit by properly inserting the bushing.

Caution

Insufficient fastening of the screw may cause some CD’s to skip.

POWER SELECT SWITCH (Located on the bottom of the unit)

Change the position with a jeweler’s screwdriver, etc.

A: Your car has an accessory position on the ignition switch.

B: Your car has no accessory position on the ignition

switch.

Be sure to press the reset button after changing the switch and connecting the lines.

Key Largo (Eng) p.1-13 10 6/19/00, 10:02 AM