VOLUME

Adjusting the volume

Muting

The volume can be adjusted in steps from 0 (off) to 66 (maximum).

To increase the volume, turn the volume control to the right.

To reduce the volume, turn the volume control to the left.

Adjusting the switch-on volume

The volume level of the device when it is switched on can be adjusted.

Press the MENU button, 8.

Press the button, 7, as often as is necessary for “ON VOL” to appear in the display.

Adjust the switch-on volume with the

buttons, 7, or with the volume control.

If you set a volume level below “1”, “LAST VOL” will appear in the display. This means that whatever volume was in use before the device was switched off will be activated again when the device is switched on.

Risk of serious injury!

If the level of switch-on volume is set to maximum, the volume when switching on can be very high.

If the volume was set to maximum before switching off, and the value for the switch-on volume is set to “LAST VOL”, the volume when switching on can be very high.

Either case can result in serious injury to hearing!

You can reduce the level of the volume (mute) suddenly.

Press the main button, 2. “MUTE” is shown on the display.

Cancelling the mute

Press the main button, 2.

or

Turn the volume control, 3.

Muting during telephone operation

If your car radio is connected to a mobile tel- ephone, the radio is muted when the tele- phone is taken “off the hook”. This requires the mobile telephone to be connected to the car radio as described in the fitting instruc- tions.

If, in the course of a telephone call, a traffic announcement is made, and if traffic an- nouncements have been given priority, the traffic announcement will be played. For more information, read the section on “Traffic Infor- mation”.

Adjusting the volume for the confirmation tone (beep)

With certain functions, if you hold a button pressed for longer than two seconds, for in- stance in order to save a station frequency to a station button, a confirmation tone, or beep, is generated. The volume level of the beep can be adjusted.

Press the MENU button, 8.

Press the button, 7, as often as is necessary for “BEEP” to appear in the display.

PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH

Press the OK button, 5, or the MENU button, 8, to leave the menu. The set- tings are then saved.

Adjust the volume with the buttons, 7, or with the volume control. “0” means that the beep is off, while “9” is the maximum beep volume.

Press the OK button, 5, or the MENU button, 8, to leave the menu. The set- tings are then saved.

39

Page 10
Image 10
Blaupunkt Pasadena CD71 installation instructions Adjusting the volume, Volume