Blaupunkt RCM 104 A operating instructions Traffic Memo TIM, Automatic seek tuning start

Automatic seek tuning start

Prerequisite:

The priority for traffic announcements is ac- tivated. If you leave the reception area of your traffic program while listening to a tape or disc or when having turned down the volume completely, the car radio will automatically tune into another traffic program station.

If no such traffic program station is found within approximately 30 seconds, tape or disc reproduction will be interrupted and the system will release a warning beep. To switch the beep off, proceed as described above.

Adjusting the traffic message volume

The volume of the warning beep and of the current traffic message was pre-adjusted at the factory. If you would like to alter the setting, proceed as described under “DSC programming - TA LEVEL”.

Traffic Memo (TIM)

This set is equipped with a digital speech	Recalling stored traffic announcements
memory, allowing up to 4 traffic messages	• Press the TIM button briefly.
lasting a maximum of 4 minutes to be auto-
	The display for example shows: NDR2 (sta-
matically recorded.
	tion name or frequency), then briefly
As soon as “TP” is displayed, the system will
record all incoming traffic announcements of	T4 14.30 (T4 = traffic message 4, recorded
	at 14:30). If four traffic messages were recor-
the adjusted station.
	ded, then “T4” always represents the most
If the priority for traffic announcements is
	recent announcement, which will also be
activated (“TA” lights up in the display), the
set will also record the traffic messages of the	played first.

traffic station program within the same radio	Use the / rocker button to switch between
network (see also “Reception of traffic an- T1 and T4.
nouncements with RDS-EON”).	Hold down the / rocker button to move
	through the message in forwards/backwards
Depending on the length of the new traffic
	direction quickly.
bulletin, the oldest messages will be deleted.
	Press << to go back to the beginning of the
If a message is longer than four minutes, the
	currently played message.
system will display OVERFLOW after four
	The TIM function is switched off by either
minutes of playback, and release a beep tone
	pressing TIM or >>.
to indicate that the message could only be
recorded partially.	TIM standby mode when the radio is
Warning	turned off
	With this system it is possible to record inco-
The motor antenna could be damaged in
	ming traffic announcements automatically at
a car wash.
	pre-determined times when the radio is tur-
If you have installed a motor antenna, then
	ned off.
please take into account the corresponding
	You may then recall such messages as des-
warning note at the end of this chapter.
	cribed above.
	If you press the TIM button while a traffic
	announcement is being played (TA lit up in
	the display), the recording will be interrupted.

DEUTSCH

ENGLISH

PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS

39