Do not connect the loudspeaker outputs to ground!
Use only the accessory and replacement parts approved by Blaupunkt.
Optical indication of theft protection
When the car is stationary, you can let the KeyCard tongue flash in order to indicate that the set is equipped with security coding. Use DSC to select one of two settings: LED ON or
LED OFF.
For more information, please read through chapter “DSC programming - LED ON/OFF”.
KeyCard
The car radio can only be operated using either KeyCard 1 or 2. Their codes are stored in the unit.
Turn on the set and introduce the KeyCard completely. The car radio is now ready for operation. When inserting a wrong KeyCard, the display will show
After approximately 10 seconds, “CARD ERR” will appear in the display. In this case do not make any further adjustments until you have the corresponding KeyCard availa- ble.
Never try to pull out the KeyCard by force.
First, slightly press the card in. This releases | Replacing a KeyCard |
the KeyCard; the display shows | Any KeyCard can only be replaced by a new |
|
“LEARNING”. Now you can pull out the card. one with the same number (1 or 2). Should | ||
Should the KeyCard be lost or damaged, | you wish to replace KeyCard 2, for example: | |
then please contact one of our authorised | ||
• Insert KeyCard 1 and switch the radio | ||
service partners to get a new card. | ||
on. | ||
The service centres are marked ( ) in the car | ||
• Slightly press the card and it will move | ||
radio service centre list. In case of doubt, | ||
into the removal position. “LEARNING” | ||
please contact the central service centre in | ||
will then appear in the display. | ||
your country for more information on the | ||
• Remove KeyCard 1 and insert the new | ||
KeyCard service centre closest to you. | ||
Use either KeyCard (1 and 2) to individually | KeyCard 2 while the display is still | |
store the following functions as desired: | showing LEARNING. | |
bass, treble, balance and fader settings, pre- | Now you can operate the set with the new | |
set stations, loudness, TA (traffic announce- | KeyCard 2. | |
ment volume), SPEECH (tone control for | You can switch the radio on only after inser- | |
speech programs), BEEP volume, SCANTI- | ting either a KeyCard 1 or 2. | |
ME, VOLFIX. |
| |
In addition to this, the settings activated be- |
| |
fore switching the radio off, such as the |
| |
waveband, station, TA priority, loudness, AF, |
| |
CPS, Dolby B/C, RM, REG ON/OFF or seek tuning sensitivity will also remain stored. When you insert your KeyCard, the basic settings you have programmed will automa- tically be activated.
32
