Blaupunkt TCM 169 Radio operation with RDS Radio Data System, Station tuning

Radio operation with RDS (Radio Data System)

If you wish to continue listening to the first programme, switch REGIONAL ON by

•pressing AF/# for approximately 1 sec- ond until “REGIONAL ON” appears in the first line.

When the regional function has been switched on “REG” will replace “AF” in the display.

If you leave the service area of the regional programme you are currently tuned into, or if you would like to take advantage of the full RDS service, switch to “REGIONAL OFF”.

•Press AF/# for approximately 1 second until “REGIONAL OFF” appears.

Station tuning

Seek tuning /

•Press /; the car radio will automati- cally search for the next station.

If you hold down / (also applies to re- mote control operation), seek tuning will speed up in upwards or downwards direc- tion.

Manual tuning:	DEUTSCH
• Press << / >>; the frequency will
change in degrees in the downwards
or upwards direction.
If you hold down the right or left part of the
rocker switch, the frequency scan will speed	Radio
up in the corresponding direction.
Entering the frequency directly
For FM or FMT, it is possible to enter the	Telefon
station frequency directly.
Start your entry
• by pressing 0.
• Then enter the frequency, beginning
with the first digit. You need not enter

Selecting a waveband

You can select between the following wave- bands:

Seek tuning

Up

Down

<</ >> Up/Down in increments (for FM only when AF is switched off)

a decimal point.	ENGLISH
Press CL to cancel this process or OK to
confirm your selection.

FM 87.5 - 108 MHz

MW 531 - 1602 kHz

LW 153 - 279 kHz

•Use BND to select the waveband. Press repeatedly if necessary.

Manual tuning with << / >>

You can also tune in a station manually.

Important:

AF must be switched off (i.e. the “AF” or “REG” symbol does not light up in the dis- play).

If necessary, deactivate this function:

•Press AF/#.

Radio

Telephone

83