OPERATION - BREWING COFFEE
1.Unlock the pod holder by pulling the LOCKING LEVER fully forward.
2.Pull the BREW TRAY fully forward, then lower tray.
NOTE: Normally, the brewer will automatically discard the last pod. If the brewer has not been used for some time, the used pod may need to be removed by hand. Deposit the used pod in the pod bin.
3.Center a fresh pod on the grid of the LOWER POD HOLDER.
4.Raise the BREW TRAY and slide fully to the rear.
5.Gently pull the LOCKING LEVER DOWN, then push it fully to the rear to lock the pod holder.
6.Place an EMPTY cup on the CUP GRID, under the BREW NOZZLE.
7.When the READY light glows, press the appropriate BREW KEY. Fresh coffee (or tea) will begin to fill the cup.
Three beeps will sound. When all dripping stops, beverage is ready to serve.
SUGGESTION: If the brewer is likely to remain unused for some time, discard the used pod:
1.Unlatch the pod holder by pulling the LOCKING LEVER fully forward.
2.Pull the BREW TRAY fully forward. This will automatically eject the used pod.
3.Slide the tray fully to the rear. In order to prevent an unintended brew, do not lock the pod holder.
CAUTION:
BURN HAZARD
Exposed surfaces of the brewer may be HOT to the touch, and can cause serious burns.
CAUTION:
BURN HAZARD
To avoid splashing or overflowing hot liquids, ALWAYS place an EMPTY cup on the cup grid before starting the brew cycle. Failure to comply can cause serious burns.
CAUTION:
BURN HAZARD
After a brew cycle, pod holder and used pod may be HOT. Remove and dispose of used pods with care. Failure to comply can cause serious burns.
NOTE: Press the same BREW SELECT KEY at any time during the brew to CANCEL.
FOR HOT WATER: Place an empty cup on the CUP GRID under the
FAUCET NOZZLE. Press the HOT WATER DISPENSE button. Release the button to stop the flow.
NOTE:
Hot water dispense is disabled during brew cycle.
If the EMPTY DRAW light is lit, the used pod bin is full. Remove the drip tray assembly, then withdraw and empty the POD DRAWER.
9
