CONFIGURATION 13:
EMERGENCY VOICE ANNOUNCEMENT OVERRIDE
Voice Announcement Override is a
The Override feature includes a quad beep
INSTALLATION:
STEP 1: Assembling Modules and Connecting the Amplifier
•Refer to step 1 on pages 5 and 17.
STEP 2: Connecting the Paging Amplifier
•Follow the same procedure described previously on page 5 or 17, step 5.
STEP 3: Connecting Optional Equipment
•Attach a
•Connect the audio output from the ProHold labeled Line 600 using the supplied RCA cable to the RJ11 modular jack terminals Y (yel- low) and BK (black).
•Using the supplied stereo
•Connect the TIP wire to one of the terminals on the normally open connections of the
•Connect the BARREL wire to the RJ11 modular jack terminal BL (blue). At this point you should have two wires connected to the BL (blue) terminal.
•Connect the RING wire to the RJ11 modular jack terminal W (white).
•Connect a
STEP 4: Switch and Control Settings
•Set the
STEP 5: Testing Your System
•Connect the power supply PCMPS2 to the PCMCPU module to either the power jack 12V DC input or wire it to the 12V DC screw terminals, observing polarity.
•Connect the Bogen amplifier to the AC power outlet (120V AC 60Hz).
•Set the volume on your Bogen amplifier to a half turn.
•Insert a
•Once the ProHold announcer has downloaded the audio and the LOAD light goes "OFF", press the normally open customer supplied switch once and listen for the
29