Bogen PCM2000 manual Music Source Bogen TP30D, Pcm Tim

CONFIGURATION 15:

SINGLE AMPLIFIER BACKGROUND MUSIC LINE-LEVEL SIGNAL

Single amplifier BGM operation is a programmable feature that lets the PCM2000 use the paging amplifier to provide high-power BGM to the 25/70V AC speakers when the paging system is idle.

INSTALLATION:

STEP 1: Connecting Telephone System Paging Output to the PCMTIM

•Refer to paging access modes described previously in Step 2 on pages 5 (paging port/contact closure), 7 (paging port/VOX), 9 (loop start trunk), 11 (ground start trunk), or 13 (station level/Centrex).

STEP 2: Connecting the BGM Source

•Connect the BGM source output to the PCMTIM module terminals labeled BGM SOURCE IN/RT.

STEP 3: PCMCPU Switch Settings

•Remove the switch lock on the PCMCPU module and place the PROGRAM/RUN switch to the PROGRAM position (down), the green LED will illuminate.

STEP 4:Testing the System

•Access the PCM2000 system (either use a single 2500-series line telephone or butt set or dial the paging access number from the tele- phone system).You will hear 3 beep tones indicating access to the programming mode.

•Dial 019 follow by the ( # ) key.You will hear a short double beep if the programming was accepted and stored in the system.

STEP 5: Prepare System for Operation

•Hang up the programming phone and then place the PROGRAM/RUN switch in the RUN position.The green LED will go out. Replace the switch lock.

Music Source

Bogen TP30D

POWER UP BAND MSCAN M1 M2 M3

TP30D DIGITAL TUNER

DOWN MONO ME M4 M5 M6

BOGEN

PCM

TIM

S1

S2

S3 TEL

S4 INT

S5 SEL

S6

S7

0 1

POWER

TONE VOLUME

BGM SRC

VOLUME

NIGHT RING

TEL

LINE

OVER RIDE

IN

	BGM
RT	SRC
NC
COM	RLY ONE
NO
NC
COM	RLY TWO
NO
GND ST

32