SECTION II - PROGRAMMING
SYSTEM PROGRAMMING
System programming lets you set certain PCM options and tone features using the DTMF keys of a telephone. It also lets you program pag- ing zone groups and signaling zone groups.
All programming is accomplished through the TEL LINE jack on the PCMTIM module regardless of the telephone interface used.
Note:To simplify initial programming, it is recommended that you use the Loop Start Trunk configuration with a
You do not need to program the system to set the zones.The system is ready from the factory to access individual zones and
To program the PCM2000 system, follow these instructions:
PCM
CPU
S1
S2 SYS
S3 ID
S4
01
POWER
RUN
PROGRAM
1. Remove the switch lock on the PCMCPU module and place the PROGRAM/RUN switch to the PROGRAM position (down).The green LED will illuminate.
2.Access the PCM2000 system (either use a single
3.You will hear 3 beep tones indicating access to the programming mode.
4. Dial the Feature Code for the option you wish to program. (See Feature Codes and Defaults list.)
Note:After you have entered a Feature Code (and any other data), you must press the [#] key to enter it into the system. If the system accepts the code (and data), you will hear a short double beep confirming that the data has been stored in the system.
Continue with the next Feature Code immediately after the confirming double beep.
If the information is not accepted, you will hear a busy tone. In this case, you should
5.Once you have finished programming, you must first
Remember to press the [#] key after you enter a Feature Code.
34
