Bogen PCM2000 manual

CONFIGURATION 2:

PAGE PORT VOX CIRCUIT - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS

This configuration is for Page Ports without Contact Closures. A dry audio pair connected to pins 3 & 4 of the TEL LINE jack on the PCMTIM module is used to detect audio and activate the system. Paging ends when the VOX timer or default timer times out. Pins 1, 2, 5 & 6 are not used in this configuration.

Note:The audio pair (page port) must pass DTMF in order to select a zone.

The required setup includes: PCMTIM - PCMCPU - PCMZPM - PCMPS2. Modules must be assembled, from left to right, in this order.

INSTALLATION:

STEP 1: Assembling Modules PCMTIM to PCMCPU and to PCMZPM

•Follow the same procedure described previously on page 5, step 1.

Note: Do NOT connect the PCMPS2 (power supply) at this point.

STEP 2: Connecting Paging Port/VOX from the Telephone System to the PCMTIM Module

•	Take the page port (VOX) audio pair from the telephone system and wire it to the RJ11 TEL-LINE jack in the PCMTIM module to pins
	3 & 4 (red and green).

•Use a 4- or 6-pin modular cord to connect the RJ11 to the TEL-LINE input on the PCMTIM module.

STEP 3: Switch Settings

•Set the TEL-INT-SEL DIP switches on the PCMTIM module for Page Port VOX configuration: switches 1 & 7 ON (to the right) and switches 2, 3, 4, 5 & 6 OFF (to the left).

•Set the SYS-ID DIP switches on the PCMCPU module to the OFF position (to the left).

•Set the RUN-PROGRAM switch on the PCMCPU module to the RUN mode (up).

• Set the Talk Back DIP switches on the PCMZPM module to the OFF position (to the left) for all zones.

•Set the OUTPUT switch on the PCMZPM module to the HI-PWR position (down).

STEP 4: Testing your System

•Follow the same procedure described previously on page 5, step 4.

STEP 5: Connecting the Paging Amplifier

•Follow the same procedure described previously on page 5, step 5.

STEP 6: Connecting 25/70V AC Speakers

•Follow the same procedure described previously on page 5, step 6.

STEP 7: Testing your System

•Follow the same procedure described previously on page 5, step 7.

7