Bogen PM-3000, PM-3180 A1 LNK IN

Programming

This function disconnects the power amplifier input from the preamp pro-

cessing circuit and permits the addition of outboard signal processing equip-

ment (such as an equalizer or ambient noise response unit) to the Audio

Process RCA connectors on the rear of the amplifier chassis. The link is

illustrated graphically below:

1. Enter programming mode and press the NEXT or BACK buttons until

AMPLINK appears on the display.

2. Press ENT to enter the function.

The display shows the the cur-

rent amplifier and link status (the

default is Amp 1, Link In).

3. Select the desired amp by press-

ing the appropriate AMP button.

4. Press the NEXT/BACK buttons

to toggle the status between IN

and OUT.

5. Press ENT to store the selection. The PROG light will blink to indicate

that data was stored.

6. Repeat steps 3, 4, and 5 for additional links.

7. Once the Amp Link function has been set, press EXIT to return to the

function menu. At this point you can exit the programming mode or

press NEXT or BACK to select another function.

Note: “IN” means that the internal connection between the

power amp and the preamp is connected. Set status to OUT

when inserting external equipment.

Note: The change in status only becomes effective after exiting

the program mode.

A1 LNK IN