Programming
Factory Defaults
This function lets you quickly erase all current configuration programming
and return the amplifier to its out-of-box configuration.
1. Enter programming mode and press the NEXT or BACK buttons until
DEFAULTSappears on the display.
2 Press ENT to enter the function.
The display shows: CLR ALL NO,
referring to Clear All (stored pro-
gramming)? = No.
3. Press the NEXT/BACK buttons
to toggle between NO or YS (for
YES).
4. Press ENT to confirm the
selection.
5. If YS is selected, the display asks
U-SURE NO. for a second confirma-
tion.
6. Again, press the NEXT/BACK
buttons to select YS and press
ENT.
If YES, the defaults will be reset
and you return to the function menu.
If No is selected, programmed defaults are left intact and you return to
the function menu.
7. Press EXIT to leave program mode or NEXT or BACK to select another
function.
Note: The defaults will be installed immediately without exiting
the program mode. They can then be viewed and adjusted by
selecting the different functions from the function menu.
Remember however, that changes in microphone input configu-
ration and amp link status will not become effective until you
exit the program mode.
CLR ALL NOU-SURE NO37