Quick Start
Basic Wiring
1. Temporarily set the AUX INPUTTRIM
controls on the rear panel to their full
counterclockwise position. Trims will
be adjusted later.
2. Be sure that the voltage select switch
is set correctly. Connect the power
cord to the AC LINE INPUT
3. Connect outputs.
For the PM-3000, connect the correct
style output (balanced or unbalanced)
to the input of the external amp or
other signal processing equipment.
Refer to page 15 for wiring balanced
or unbalanced outputs.
For the PM-3180, connect loads
between COM and the desired
output tap (8Ω, 25V or 70V). If
connecting a 4-ohm load, refer to
the Wiring Information section on
page 16 for information on the
4Ωlink.
4. Connect unbalanced music input
sources. The lines from the sources
to the amplifier should be terminated
with RCA-type plugs.
5. Connect balanced, low-impedance
microphones. For the 3-pin Mic A
connector, pin 1 is ground (shield).
6. Plug the ProMatrix into a properly
grounded wall outlet.
5
+