FLEXIDOME 5000 AN | Connection and |
|
|
4Connection and set-up
4.1Power and video connections
The wiring harness has a BNC connector to accept the video coax cable (with male BNC connector) and two stripped low voltage power wires for connection to a power connector. A UTP adapter
The easiest way to connect the cables is as follows:
1.Bring the building connections through the surface cable hole so that they hang clear.
2.Partially insert two screws into the
3.Using one of the keyholes, hang the mounting base of the camera module on one screw temporarily; tilt the base slightly to gain access to the cable connections.
4.Connect the BNC connector of the camera module to the video coax cable.
5.Connect the stripped power wires (red +, brown
Note
For a DC supply the polarity is important. Incorrect polarity does not damage the camera but it will not switch on.
6.In damp environments ensure that the connections are sealed. (The surface mounting box and the other mounting accessories have a sealed compartment for this purpose.)
7.Push the connections back through the surface cable hole.
8.Secure the mounting base of the camera module to the surface with three screws.
Bosch Security Systems | Installation Manual |