14 en Installation | FLEXIDOME 5000 AN |
|
|
Surface mounting box
Camera module and mounting base
Inner liner (with sealing ring)
Trim ring
Dome
Figure 3.2
To disassemble the unit proceed as follows:
1.Use the special screwdriver bit to loosen the three tamper- resistant screws in the trim ring (the screws remain in place).
2.Remove the trim ring and dome by pulling them from the base.
3.Remove the inner liner (with sealing ring) by pulling it off of the base.
4.Remove the pink protective foam.
3.3Mounting the unit
There are several ways to mount the unit. The method of mounting depends on the type of surface and whether other mounting hardware, such as an electrical box, a surface box or other accessories are used.
Note:
Installation Manual | Bosch Security Systems |