AutoDome 700 Series IP PTZ Camera | Configuring the AutoDome 700 Series en 33 |
|
|
CAUTION!
The AutoDome disables the Privacy Mask function if the orientation is set to Inverted.
SC Settings
Click the Default button to restore all camera settings to their original defaults.
SC Data
Click the default button to clear all preposition, privacy mask, and other user settings.
Reboot Device
Performs a reboot of the AutoDome. There is a ten (10) second pause before the dome starts its homing phase. During the homing phase the camera pans left and right and tilts up and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40 seconds.
Factory defaults
Click Restore all defaults to restore the factory defaults for the camera. A confirmation screen appears. Allow 5 seconds for the camera to optimize the picture after a mode reset.
4.19Encoder Profile
For the video signal encoding, you can select a code algorithm and you can change the presets for the profiles.
You can adapt the video data transmission to the operating environment (for example network structure, bandwidth, data load). To this end, the AutoDome 700 Series simultaneously generates two data streams (Dual Streaming), which compression settings you can select individually, for example one setting for transmissions to the Internet and one for LAN connections.
–High resolution 1
Target bit rate: 2000 kbps
Maximum bit rate: 4000 kbps
Encoding interval: 30.00 ips
–High resolution 2
Target bit rate: 1500 kbps
Maximum bit rate: 3000 kbps
Encoding interval: 30.00 ips
–Low bandwidth
Target bit rate: 700 kbps
Maximum bit rate: 1500 kbps
Encoding interval: 30.00 ips
–DSL
Target bit rate: 400 kbps
Maximum bit rate: 500 kbps
Encoding interval: 30.00 ips
–ISDN (2B)
Target bit rate: 80 kbps
Maximum bit rate: 100 kbps
Encoding interval: 30.00 ips
Bosch Security Systems, Inc. | User Manual | F.01U.273.798 3.0 2012.08 |