Remote control
6.4"Priority" function
Temperature cannot be
imemorized or changed using the heater's
control panel buttons or a second remote control when hot water is in use (e.g. during a shower)
The "Priority" function will automatically activate to stop another user from modifying the temperature when hot water is in use.
The remote control does not have a default temperature setting and therefore has no default "Priority" function.The "priority" will be attributed automatically by the first user who selects or memorizes (on the remote control or on the heater’s control panel) a temperature for subsequent use (e.g. a shower).
Then, when the hot water is used (e.g. for a shower), the heater's display and additional remote control displays will
show the symbol " 
".
The temperature may only be modified using the same buttons that set it (depending on whether the control panel or the remote control was used).
The priority device will not have the
symbol " 
".
To clear a device that is locked out with
the " 
" symbol (with no hot water running) simply:
Bpress and hold both the " 
" and
" 
" buttons on that device for 5 seconds.
The "Priority" function ends:
•5 minutes after the last use of the hot water (return to basic set up).
•2 minutes after selecting/ memorizing the temperature if no hot
water is used immediately afterwards.
Acquiring "priority”
Any user can acquire "priority" for subsequent use of hot water, as follows:
BMove the heater's main switch to the ON position (I).
BPress and hold " 
" or " 
" to select the desired temperature.
BPress and hold the "Program" but- ton until the symbol "Pr" appears on the remote control display.
B Use the hot water within two minutes of acquiring "priority”.
6 720 606 990 | 15 |
