Remote control installation
BOn heater control panel, press and
hold Program key 
while pressing the ON/OFF button to ON. Release program key when LCD displays “188”.
LCD shows “P2”. If not, repeat previous step.
B Press ON / OFF button on the appliance to OFF position and then back ON.
B Press buttons 
or 
to reach desired temperature.
New remote control is programmed.
1.Press the 
button on the heater to select "P3".
B Press and hold Program key again for 1 sec.
LCD shows one number and one rotating digit. If not, repeat previous step.
The number represents the remote control which is to be registered, the first remote control will be registered with number “0”, the second with number “1” and so on.
The rotating digit shows that the electronics is expecting a registration. If the LCD fails to show a number and rotating digit after repeated attempts, double check the wire connections made in section 5.1.
B Hold remote control in front of the control panel on the heater and simultaneously press remote control
buttons 
and 
until the temperature indication is shown on the remote control LCD.
12 | 6 720 606 990 |
