Remote control installation
B Switch power switch on the appliance to the "OFF" (0) position and then back "ON" (I).
B Press buttons 
or 
in order to reach desired temperature.
New remote control is programmed.
4.2.2 SU board
BConnect power to heater.
B Move the main switch on the appliance to the "OFF" (0) position.
BPress and hold 
key while at the same time turning the main switch to “ON” position (I).
LCD shows one number and one
rotating digit. If not repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.1.
B Hold remote control in front of the control panel on the heater and
simultaneously press remote control
buttons 
and 
until the temperature indication is shown on the remote control LCD.
B Switch ON/OFF switch to “OFF” position (0) and then back on (I).
B Press buttons 
or 
in order to reach requested temperature.
New remote control is programmed.
6 720 606 990 | 9 |
