Bosch Appliances NIN-832 Analog video output, Alarm Input, Alarm output, Audio in / Audio out

24 en Installation FLEXIDOME HD VR

CAUTION!

The RJ45 female-to-female network cable connector supplied is unshielded. To comply with the EMC Alarm immunity standard (EN 50130-4) or the EMC Railway immunity standard

(EN 50121-4), a shielded twisted pair (STP) connection cable and a shielded RJ45 female-to-female network cable connector (not supplied) should be used.

Analog video output

Connect to the BNC connector to obtain an analog video signal. This is a CVBS 1 Vpp PAL or NTSC signal (depending on the selected camera base frequency).

Note:

If necessary, use an isolation transformer to avoid ground loops.

Alarm Input

Use the alarm input to connect external alarm devices such as door contacts or sensors. A zero potential make or break contact can be used as the actuator (use a bounce-free contact system).

–Refer to the cable tree table to identify the wire colors for connecting the alarm input.

–Configurable as active low or active high.

Alarm output

Use the alarm relay output for switching external devices such as lamps or sirens.

–Refer to the cable tree table to identify the wire colors for connecting the alarm output.

–In the menu system, configure the relay output to operate as either normally open (NO) or normally closed (NC).

Audio in / Audio out

The unit has full-duplex mono audio. The two-way communication can be used to connect a speaker or door

AM18-Q0637 v1.1 2013.08 Installation Manual Bosch Security Systems