Application Note

Bosch Sensortec

BlueBox Demo-Board for the digital sensors AN18002

SMB365 (acceleration) and SMD500 (pressure)

3.2Bluetooth wireless

1.Make sure that the used PC or laptop supports Bluetooth capability.

2.Make sure that system specific Bluetooth hard- and software as well as drivers are installed and activated.

3.Before using wireless data transmission via Bluetooth start up the BlueBox once according to chapter 3.1 and let the BlueBox connected at least 5 hours to fully charge the battery pack.

Main Switch

Bluetooth Device ID

Bluetooth unit

4.Double Click on the Bluetooth symbol in the system tray or start your Bluetooth software to set up the correct Bluetooth environment for the BlueBoard.

o Bluetooth software must support SPP Protocoll (Serial Port Profile) and virtual serial COM port respectively

o Configure according to “Pair Devices” or “Pairing”

5.Turn on the BlueBox demo board (USB cable disconnected) for wireless use

6.Search for the corresponding Bluetooth Device ID in Bluetooth environment in this example “7763” according to the illustration above

o When asked for Bluetooth Pin or Key enter “0000”

8. Execute the SensorDesktop software on the PC from Start\Programs\ SensorDesktop

Rev. 1.0

Page 19

© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such copying and passing onto third parties.

7211RB11