Application Note

Bosch Sensortec

BlueBox Demo-Board for the digital sensors AN18002

SMB365 (acceleration) and SMD500 (pressure)

9.After starting the software, the cockpit window of the BlueBox software appears. The software tries to locate automatically the corresponding virtual COM port of the demo board. If the demo board is located, a status message at the bottom left hand corner of the software window will indicate, to which COM port the module is connected. If the status window indicates “Module not found” the board has to be located manually. Only in this case click on “File” Æ “Detect Module on COM Port” in the status bar.

Select „File“ Æ “Detect Module on COM Port” for manually COM port location

Start data acquisition

Status window

10.Press the „Start“ button to start data acquisition of acceleration and pressure sensor

11.Accelerate, roll, tilt or lift the BlueBox board

12.Watch the graphs in the different displays on the cockpit screen

oNote: For exact altimeter response it is strongly recommended to correct the ambient air pressure data before further using the board (see chapter 3.3)

Rev. 1.0

Page 20

© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such copying and passing onto third parties.

7211RB11